Pearl Necklace Bibs

I've been working on these designs for days and busy making samples. I am going to make one more sample for pearls of the same size.

For the one-fabric one I used white jersey, but it is too stretchy and I forgot to interface it. The area around the pearls puckered a little as it is pretty dense. I digitized 4 runs for the pearls(each run slightly larger than the previous one) and this one had 3 runs and the pearls look quite dimensional.

For the two-fabric one, the pearls turned out very nicely, but I only stitched Run 1 for the pearls.

The last one was made long time ago and it had all 4 runs of the pearls. I've made a lot of improvements since then but you can see how raised the pearls are when you run all 4 colors.

The design set can be found here:
https://www.etsy.com/listing/166894724/in-the-hoop-pearl-necklace-bibs?ref=shop_home_active

Designs in the set:

There are four varieties as follows in each size:
Variety 1: One-fabric version with pearls of the same size;
Variety 2: One-fabric version with pearls of different sizes;
Variety 3: Two-fabric version with pearls of the same size (the front has a border fabric and a different center fabric);
Variety 4: Two-fabric version with pearls of different sizes.

Four different hoop sizes are included in this set and they each has different formats included. The files are organized by hoop size first then by format.
1. 180mm*300mm (PES, DST)
2. 200mm*300mm (PES, DST, VP3, HUS, JEF)
3. 200mm*260mm ( PES, DST, VP3, HUS, JEF)
4. 230mm*300mm (JEF, DST)