by BabyAbyss 23 Jan 2013

Help needed! is there someone that wouldnt mind helping me with an embroidery problem. I need someone to test stich a design for me. ive stitched the design myself and the fill stitch has come out fantastic. However the stitching around the outter edges of the design have stiched of center leaving a small gap at the top on boths sides. Now i checked my design and according to my design layout there isnt a problem. I had this problem with something else the other day and im wondering if my machine may be slightly out rarther than the problem lying with my design. I would really appreciate someones help so i know whats going on with my designs. The design is 10cm x 10cm

heres a computer image of the design in question

Thanks
Tina

4779

Comments (3)

by kezza2sew 23 Jan 2013

looks like it will be a lovely design with all the hearts as fill stitches..
good luck with the edge.

1 comment

by BabyAbyss 24 Jan 2013

thank u, somehow i think i'll need it ;)

25546

by noah 23 Jan 2013

When finished send me a private and i will test /sew it for u ok hugs carolyn

1 comment

by BabyAbyss 23 Jan 2013

thank u noah. very kind of you. i need to do some more work on it yet. i have tryed to make the ajustments already but still wasnt successful so need to try again and then i will send you the file to test for me. Thank u

360366

getEdited - SELECT

by basketkase edited 23 Jan 2013

Tina.....I hope one of the other digitizers can help with this as well, but in my experience, when this happens it is usually the pull compensation that needs adjusting......the pull comes from the fabric being pulled as it stitches a fill, so you have to adjust your design for this.....I have pull compensation settings that are automatic depending on what type fabric I am stitching on...however, I can also change the pull manually........I am not as versed on this as I would like to be and it is still somewhat confusing to me, but this may be your problem...

Vicki

5 comments

by sewmom 23 Jan 2013

I agree. I'm actually stuck on a design with this problem right now. I need to take it to my teacher.

by BabyAbyss 23 Jan 2013

thanks Viki, is it the pull compensation on the fill stich i need to adjust or on the outter border? im new to all this, i only started a month ago

by basketkase 23 Jan 2013

Tina...you are doing so awesome, no one would guess you have only been at it a month. I usually do pull compensation on the area where the pulling is greater, in this case the fill...

by basketkase 23 Jan 2013

Sewmom.....let us know what your teacher says, as I never had formal training and would like to really understand this pull stuff!!

by BabyAbyss 23 Jan 2013

thanks for yr advice viki, i really appreciate it. I'll give it a try now n see how it goes. i'll let u know how i go on ;)

261161